|
ROLLER PILOT BEARING FOR 289 / 302 / 351C AND 351W -- M-7600-A
|
|
BOSS 302/351W MAIN BOLT WITH STUD (SINGLE) -- CM-6345-A
|
|
|
|
|
|
- Production roller pilot bearing fits 289, 302, 351C and 351W crankshafts
- Designed for .669 diameter input shaft
NOTE: Pre-greased - do not add extra grease. Clutch and bearing damage may occur
|
- Fits Ford Racing's Boss 302/351 and production 351W blocks
- 1/2 inch main bolt with 3/8 stud, provides attachment point for rear sump pickup tube support bracket.
- Under hex length 3.450" Hex head thickness .540" 3/8 stud length .650"
- Limited Supply
|
|
|
|
BOSS BLOCK STANDARD CAMSHAFT BEARINGS -- M-6261-J351
|
|
FORD RACING ARP CYLINDER HEAD BOLT KIT -- M-6065-D289
|
|
|
|
|
|
- Fits 302/351W Ford Racing Blocks
- Common outer diameter service replacement cam bearings for use in the following Ford Racing cast iron blocks:
- M-6010-R302
- M-6010-S302
- M-6010-R351
- M-6010-R352
- M-6010-S351
- M-6010-V351
- M-6010-W351
- M-6010-R451
- M-6010-R452
- M-6010-R453
- M-6010-B302BB
- M-6010-BOSS302
- M-6010-BOSS35192
- M-6010-BOSS35195
- M-6010-BOSS351BB.
- Use with standard/conventional/off-the-shelf camshaft designs where the 1-4 bearings are common but the 5the bearing is a different size. If your camshaft is a custom ground camshaft with 1-5 common bearings, then you need to use M-6261-R351 cam bearing kit.
|
- Use when installing stock 351W, Ford Racing cast iron (M-6049-L302/L303) or Ford Racing aluminum head (M-6049-Y302/Y303/X302/X303/X304/X305/X306/X307) on 289/302 blocks
- Kit features 20 ARP cylinder head bolts with 7/16" diameter thread
- Includes 20 special stepped washers
- Sold in engine sets
|
|
|
|
FORD RACING BOSS CYLINDER HEAD BOLT KIT -- M-6065-BOSS
|
|
FORD RACING 351W "Z" HEAD STUD KIT -- M-6014-Z304
|
|
|
|
|
|
- 1/2" cylinder head bolts required for installation of the Ford Racing M-6049-X306/X307/Z304DA heads onto the M-6010-BOSS302, M-6010-B302BB, M-6010-BOSS35195, M-6010-BOSS35192, M-6010-BOSS351BB blocks.
- Includes hardened washers
- Sold in engine sets
|
- Use when installing M-6049-Z304/Z304A/Z304D/Z304DA heads on a 351W block (except Boss 351 block)
- 1/2" diameter studs with 12-point nuts and hardened washers
- Sold in engine sets
|
|
|
