M-6066-M8 Ford Performance 2018-2021 Mustang GT 5.0L 750hp Supercharger Kit

This new Mustang GT supercharger has been developed by Ford Performance in partnership with Roush Performance, utilizing engineering expertise from both companies. Ford Performance and Roush are known for high-quality work, a vast support network, and having the utmost knowledge of the Ford powertrains with a working relationship that goes back 50 years.

The R2650 Supercharger features new TVS Technology. The new Twin Vortices Series features new four-lobe rotors and high-flow inlet and outlet ports that greatly enhance thermal efficiency, enabling greater volumetric capacity at higher revolutions per minute (RPM).

The Ford Performance supercharger kit is warranty friendly and rated at 750 horsepower. This new kit has been developed specifically for the new 5.0L V8 that features dual-fuel, high-pressure direct injection and low-pressure port fuel injection technology for increased power and efficiency.

• Fits 2018-2021 Mustang GT with AUTOMATIC or MANUAL transmission
• FREE 3-year/36,000-mile Limited Powertrain Warranty included when installed by a Ford dealer or an indepedent ASE Automotive Service Excellence-certified technician. Warranty is based off the new vehicle in-service date.
• Produces 750 HP and 670 lb-ft of torque at approximately 12 psi of boost with 91 octane fuel
• Kit comes complete with all hardware for installation
• Exclusive calibration is 50 state emissions legal. CARB approved for 2018 thru 2021 Mustang GT.
• NOT compatible with the BULLITT edition Mustang
Kit includes:
• 2.65L Twin Vortices (TVS) supercharger assembly
• Lower intake manifold with intercooler
• 87mm electronic throttle body
• Hi-flow cold air inlet system with performance air filter
• Fuel rails
• Complete air-to-liquid intercooler system includes:
  • Intercooler pump
  • Heat exchanger
  • Intercooler reservoir
  • Hoses
• Harnesses
• Brackets
• Hardware
• Spark plugs
• Drive belt
• First sheave FEAD system with tensioner and idler pulleys
• 47 lb/hr, 6-hole, high-impedance fuel injectors
• Performance Calibration installation requires laptop and internet access with a shop tool SAE J2534 pass thru device.
• The M-6066-M8 Mustang Supercharger Kit from Ford Performance Parts also features an updated calibration which increases output to 750hp/670 lb-ft. from 700hp/610 lb-ft.. The upgraded calibration has been included with kits installed in 2020. Customers can confirm that they have received the updated calibration by reaching out to the Ford Performance Parts Techline with their VIN for verification of their calibration. Additionally-kits will indicate 'P2' on the voucher card

NOTE: Powertrain calibrations are developed and supported for U.S. and Canadian vehicles only. Federal and state laws prohibit any person from installing aftermarket add-on or modified parts prior to the sale of a new motor vehicle