Ford Performance 5.2L Shelby GT500 Engine Manual Control Pack

M-6017-M52SC

• Take the complexity and mystery out of wiring the 2020+ GT500 supercharged engine!
• Designed to run M-6007-M52SC GT500 crate engine with a manual transmission
• PCM with Ford Performance calibration
• Electronic Throttle Control accelerator pedal, eliminating throttle cable routing problems
• Unique control pack harness, which replaces the stock body harness and is designed for custom vehicle builds
• OBD-II diagnostic port to assist in vehicle calibration upload and problem diagnosis
• Power distribution module
• Ambient Air Temperature Sensor
• Clutch Position Switch
• HEGO sensors (primary oxygen sensors only)
• For projects locating the HEGO oxygen sensors in locations different from the production mustang locations, the PCM will need to be re-calibrated by an aftermarket dyno tuner to run proplery.
• PCM with Ford Performance calibration requires return type fuel system, will not work with returnless fuel system
• NOTE: Installation of this PCM in a production GT500 will result in a no-start condition.
• This installation setup does not include provisions for: Cruise Control, A/C, ABS, Electronic Traction Control, or OEM Anti-Theft Systems. If doing a Coyote motor swap into a production vehicle chassis for racing only with these systems, then these various systems will be turned off.
• Not for use with 2007-2014 GT500 engines
• Not for use with GT350 5.2L engines