Ford Performance 2015-2017 Gen 2 5.0L Mustang GT Coyote Engine Control Pack

M-6017-504V

• Take the complexity and mystery out of wiring the lastest 2015+ 5.0L 4V 435HP Coyote engine in your project vehicle!
• Designed to run the M-6007-M50A and M-6007-A50NAA 5.0L 4 Valve 435HP crate engine and salvage motors pulled out of 2015+ Mustang GT Manual Transmission Cars.
• Will also work on M-6007-A50SCA with aftermarket custom software tuning and Mustang GT engine harness from a manual transmission car. The compression ratio of this motor is different and requires a custom tune to run properly.
• Will NOT work on 5.0L motors sourced from the F-150.
• DOES NOT CONTROL AUTOMATIC TRANSMISSIONS. ONLY CONTROLS THE ENGINE. We recommend using one of the aftermarket standalone transmission packages we offer that have their own transmission controller included. Ford Performance Engine and Transmission Control Pack M-6017-M50A is available but can only be used with a compatible Ford 6R80 automatic transmission. Other transmissions will need to use this engine only control pack and an aftermarket standalone transmission package.
• Includes PCM with Ford Racing calibration for M-6007-M50A and M-6007-A50NAA
• Includes Electronic Throttle Control accelerator pedal eliminates throttle cable routing problems
• Unique controls pack harness replaces stock body harness and is designed for street-rod/project vehicle installation
• Features OBD-II diagnostic port to assist in vehicle calibration upload and problem diagnosis
• Includes unique downsized power distribution module, Air box, inlet tube, MAF sensor with bolts, and UEGO sensors
• For projects cars not using the included air box and air intake tube, the PCM must be re-calibrated by an aftermarket dyno tuner to run. Custom air induction setups will throw off the PCM calibration provided which is why you need a custom dyno tune.
• For projects locating the UEGO oxygen sensors in locations different from the production mustang locations, the PCM will need to be re-calibrated by an aftermarket dyno tuner to run.
• PCM with Ford Performance calibration requires return type fuel system, will not work with returnless fuel system
• NOTE: Installation of this PCM in a 2015+ Mustang GT will result in a no-start condition.
• This installation setup does not include provisions for: Cruise Control, ABS, Electronic Traction Control, or OEM Anti-Theft Systems. If doing a Coyote motor swap into a production vehicle chassis for racing only with these systems, then these various systems will be turned off.