2011-2014 5.0L COYOTE 90MM THROTTLE BODY -- M-9926-M5090

• FLOW RATING:1132 CFM; with adapter 1101 CFM (Stock Throttle Body: 913 CFM)
  
• Fits 2011-2014 Mustang GT/ 2012 Boss 302 (stock is 80mm)
• 90mm increases high rpm performance and throttle response.
• Performance throttle bodies for vehicle equipped with electronic throttle control (ETC)
• Electronic throttle control was introduced on the Mustang in 2005. It's introduction has made attention to detail and setup of replacement throttle bodies even more critical than in the past. Ford Racing throttle bodies are tested and engineered to give the customer trouble free operation and are set up from the factory ready to bolt on.
• Includes jumper harness
• Includes bolts
• Custom PCM calibration/tune required and is not included. Ford Racing's Pro-Cal tunes DO NOT support this part. An aftermarket tuner and custom calibration will need to be sourced.
  
• Requires use of vehicle dependent Ford Racing Throttle Body Adapter (read below)

All Ford Racing ETC throttle bodies feature:

• All factory sensors installed - no need to tear apart your original throttle body
• Calibrated for consistent idle using the same equipment and procedure as production throttle bodies
• The only throttle bodies backed by Ford Racing and features the Ford Racing logo CNC cut into the TB housing
• Precision billet construction with tapered inlet for consistent high flow
• Validation through hundreds of hours of dyno, racing, and street performance driving
• Polished aluminum for great looks and underhood "bling"

Required Parts that are not included with the throttle body:

• Adapter: M-9474-M50 for OEM Coyote intake (sold separately)
• Adapter: M-9474-M50B for Boss 302 intake M-9424-M50BR (sold separately)
• Requires shortening of the OEM intake tube by 1.5 inches (see install sheet for details)
• Requires a 4 inch to 3.5 inch silicone hose reducer with respective clamps for setups using the OEM intake tube. This silicone reducer is not included because customers with aftermarket air intakes will have various sized tubes and therefore may need a different silicone coupler or reducer.
• For information on where to purchase silicone hose adapter contact the Ford Racing Tech Line - 800-367-3788

Notes:

• Adapter M-9474-M50 rotates throttle body approximately 15% counter clockwise
• Engine cover M-9680-M50 covers throttle body on base Coyote intake
• Boss intake M-9424-M50BR can be port matched to accept throttle body w/out adapter, requires custom gasket/RTV